
Two drive wheels completed.

Next up section two and work began on the lower rear hull.

Doors on and towing hooks in place.

Few more bits of detail assembled ready for the next stage.

It was good to finally get hold of some more substantial parts for the build, cut from the sprue and cleaned up was the main part for the lower hull. I also assembled the front lower hull and we have all the main components to complete this part.



Running gear still not glued in as I still want to paint these as a separate and then of course could resist placing the upper hull to get a feel for things...


Moving on and back into tiny part construction again and quite surprised on one of the smaller parts I had to drill four small holes to receive the viewing periscope protection cage...




Quite a lot of hard work for what seems like not much payback on the flip side the detail is just awesome..!

Not much to show for a solid days gluing but we're pushing on and looking forward to the next sitting.

Little bit boring for the viewer right now but trying to push on, lots more to glue before we finally make it to the main event..!